But it can also be a cap that is leaking or blown.You can open the amp but disconnect the power before touching or opening.Look at the channel which is not working to see if you have a cap swollen or blown then replace it with it's same value micro farad (pf).It's difficult to say what else can be wrong but those are the first to look at.It will take even me around a hour to say whats wrong.Fault finding is what takes time. Initial release of manual M-035030, software Q0. Refer to the manual provided with the DEP-100S programming device for more Related manuals. Last of the easy stuff to check is to take your headphones and see if you get even volume of both sides don't forget to check if there is a stereo/mono switch you want this switch to be set to stereo though the sound will no change much cause your bass may be a little lower on mono.When you have finally tested all of these and no satisfaction, then one of your transistors of that channel is blown. View and download the Manual of Grasslin Famoso 1000 RF Thermostat (page 10 of 24) (English, German, Dutch, French, Italian). NOTE: The steps required to set the address are listed below. If it's only on one speaker the first check if the cable from the amp to that speaker is not ripped off.Tru swopping the speaker around to the side which is working if it still has no so sound the maybe you should check on the amp to see if you did not cut the stereo down for that channel.See that the balance dial is in the middle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |